TOA Floorguard Primer

• excellent properties for adhesion and penetrate into concrete surface.
• abrasion resistance, resistance to water, weak acid, weak basic and chemical.

  ราคาขึ้นอยู่กับเฉดสีแต่ละเฉด โปรดเลือกเฉดที่ต้องการ ได้ที่ กด " ดูเพิ่ม " จะพบแคตตาล๊อก ติดต่อสอบถามราคา  083-2393626  ,  083-2396466  หรือ  LINE : @TOPAINTS   

• For New concrete
  - The concrete prior to laying plastic sheets to block moisture from underground. Then it should be left for curing concrete to solid and dry for about 3-4 weeks. Then, clean the surface free from dust, dirt, grease and most importantly, the surface is completely dry. (Check moisture content must be less than 10%)
• For Old concrete
  - To remove the old paint film which loosely adhesion to as much as possible by Scraping with a shovel or Grinding machine to enhance adhesion. Then, clean the surface free from grease and oil with suitable solvent. Before primer coating should clean all surfaces free from dust, dirt, grease and most importantly, the surface is completely dry. (Check moisture content must be less than 10%).
• For Floor Hardener or Surface glossy finish :
  - Concrete surface preparation by using dust free captive blasting units, grinding equipment, sand blasting for increase adhesion of coating.
  - Inspect the concrete for bug holes void, fin and other imperfections. Protrusions shall be ground smooth while voids shall be filled with Floorguard Putty or other suitable filler and polishing of surface with moltoprene disk.
  - After cleaning, repair surface defects and remove detericrated previous coatings. (Check moisture content must be less than 10%).
  

• Remover all oil, grease, dirt, oxide and other foreign material by cleaning per SSPC-SP1, Solvent Cleaning before coating.
• If over 7 days gives cleaning surface by sand paper no. 320-400 and cleaning surface per SSPC-SP1, Solvent Cleaning before coating.
• Surface repaire (cracks, pores, holes) done with Floorguard Putty and polishing of surface with moltoprene disk.

• Concrete protective Coating

• The proper relative humidity in the work shall not exceed 85% RH.
• The temperature of the substrate should be minimum 10 °C and at least 3 °C above the dew point of the air , d temperature and relative humidity measured in the vicinity of the substrate for prevent moisture and water drop on substrate effective adhesion and drying time.

• Storage condition
  • The product must be stored in accordance with national regulations. Storage conditions are to keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition.
• Shelf life : 24 months at 30-35 °C

  *** ถ้ามีจำนวนขอราคาพิเศษ ติดต่อเราได้เลย ***