TOA Epoguard W

  ราคาขึ้นอยู่กับเฉดสีแต่ละเฉด โปรดเลือกเฉดที่ต้องการ ได้ที่ กด " ดูเพิ่ม " จะพบแคตตาล๊อก ติดต่อสอบถามราคา  083-2393626  ,  083-2396466  หรือ  LINE : @TOPAINTS   

• Toa EPOGUARD W is a high build two pack liquid epoxy as a primer / topcoat, containing no coal tar for use in interior lining for pipes and tank containing potable water. This product is approved according to AWWA C 210 and TIS 1048-2551 for use in pipeline transporting drinking water. As a epoxy coating for pipeline interiors and exteriors, storage tank, penstocks, surgetanks, gates, circulating water lines, Concrete and Steel. It has excellent adhesion, toughness, impact resistance, abrasion resistance, resistance to sea water and water and high resistance to cathodic protection.

• Should be blast cleaned in accordance with NACE No.2 / SSPC-SP10 / ISO 8501:1 / SIS Sa 2.5 to a near-white finish using a suitable abrasive. And/or by use the surface preparation with requirements. of the primer and/or as the Spec of the project.

• For New concrete - The concrete prior to laying plastic sheets to block moisture from underground. Then it should be left for curing concrete to solid and dry for about 3-4 weeks. Then, clean the surface free from dust, dirt, grease and most importantly, the surface is completely dry. (Check moisture content must be less than 14%)
• For Old concrete - To remove the old paint film which loosely adhesion to as much as possible by Scraping with a shovel or Grinding machine to enhance adhesion. Then, clean the surface free from grease and oil with suitable solvent. Before primer coating should clean all surfaces free from dust, dirt, grease and most importantly, the surface is completely dry. (Check moisture content must be less than 14%).

• Remover all oil, grease, dirt, oxide and other foreign material by cleaning per SSPC-SP1, Solvent Cleaning before coating.
• If over 7 days gives cleaning surface by sand paper no. 320-400 and cleaning surface per SSPC-SP1, Solvent Cleaning before coating.
• Surface repaire (cracks, pores, holes) done with TOA Epoxy putty and polishing of surface with moltoprene disk.

• The proper relative humidity in the work shall not exceed 85% RH.
• The temperature of the substrate should be minimum 10 °C and at least 3 °C above the dew point of the air , temperature and relative humidity measured in the vicinity of the substrate for prevent moisture and water drop on substrate effective adhesion and drying time.

• Storage condition
  • The product must be stored in accordance with national regulations. Storage conditions are to keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition.
• Shelf life
  • 24 months at 30-35 °C
  • The product must be stored in accordance with national regulations. Storage conditions are to keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition.

  *** ถ้ามีจำนวนขอราคาพิเศษ ติดต่อเราได้เลย ***